PASS-Key® III System Quick Learn Procedure
WARNING: This page does not describe the selected car, but rather 98 other vehicles, including the 2001 Saturn SW2, 2001 Saturn SL2, 2001 Saturn SL1, 2001 Saturn SL, and 2001 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
PASS-Key® III system quick learn procedure is used to learn additional ignition keys. A learned key must be used to initiate procedure. Up to 10 ignition keys can be learned.
- Insert a valid ignition key in ignition switch. Turn ignition switch to ON position. After 2 second bulb test, turn ignition off and remove key.
- Within 10 seconds, insert new valid mechanical code unlearned key and turn ignition switch to RUN position. Security light will illuminate until key is learned. This may happen so quickly light illumination is not observed. Turn ignition switch to OFF position. Remove ignition key 10 seconds after light goes out.
- To learn additional keys, repeat step 2. To exit procedure, turn ignition off for more than 10 seconds.