Password Learn Procedure For Anti-Theft System (6.5L Diesel)

WARNING: This page does not describe the selected car, but rather 98 other vehicles, including the 2001 Saturn SW2, 2001 Saturn SL2, 2001 Saturn SL1, 2001 Saturn SL, and 2001 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.

Password learn procedure must be performed if PCM, Passlock® module or sensor is replaced. A password is communicated between PCM and Passlock® module to provide engine operation. If PCM is replaced, PCM must learn password from Passlock® module.
Attempt to start engine. Engine will start and then stall. After engine stalls, leave ignition switch turned to ON position for 10 minutes. After engine stalls, the SECURITY indicator light will stay on for 10 minutes and then turn off. SECURITY indicator light is located on right corner of instrument panel.
NOTE: Ensure battery is fully charged before proceeding. Performing this procedure will cause DTC P1630 to be set. It will be necessary to use scan tool to check for DTC P1630 when performing this procedure. Ensure steps are followed in correct order or procedure may need to be repeated.
After SECURITY indicator light goes off, turn ignition off for 30 seconds. Attempt to start engine. After engine stalls, leave ignition switch turned to ON position for 10 minutes. SECURITY indicator light will stay on for 10 minutes and then turn off. After SECURITY indicator light turns off, turn ignition off for 30 seconds.
Attempt to start. After engine stalls, leave ignition switch turned to ON position for 10 minutes. SECURITY indicator light will stay on for 10 minutes and then turn off or until DTC P1630 is set.
Turn ignition switch to OFF position for 30 seconds. Turn ignition switch to ON position and wait 30 seconds. Attempt to start engine. If engine starts, password learn procedure is complete. Ensure DTC P1630 is cleared from PCM by turning ignition off for 30 seconds and then turning ignition switch turned to ON position again. If DTC P1630 is not cleared from PCM, perform test procedures for DTC P1630 and repair as necessary. See appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.
NOTE: DTC P1630 will be set in PCM as result of this procedure. DTC P1630 may be cleared from PCM by turning ignition off for 30 seconds and then turning ignition switch to ON position again.
If engine does not start, ensure procedure was properly followed. If procedure was properly followed, check for any DTCs. If any DTCs exist, perform test procedures for specified DTC and repair as necessary. See appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.