LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Computer Relearn Procedures) >> General Motors (Cars) >> Century, Grand PRIX, Impala, Intrigue, Lumina, Monte CARLO & Regal >> PASSLOCK™ 30 Minute Relearn Procedure (Impala & Monte Carlo)

PASSLOCK™ 30 Minute Relearn Procedure (Impala & Monte Carlo)

WARNING: This page does not describe the selected car, but rather 98 other vehicles, including the 2001 Saturn SW2, 2001 Saturn SL2, 2001 Saturn SL1, 2001 Saturn SL, and 2001 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: 10 minute procedure requires special equipment to perform. If special equipment is not available, 30 minute procedure may be used. This procedure allows relearning of BCM or PCM learned data code after replacement of Passlock™ module, Passlock™ sensor or VCM. DTC B3031 will set when entering programming mode. Reprogram BCM with proper RPO configurations before performing 30 minute relearn procedure. After reprogramming a new PCM, PCM will learn incoming fuel continue password immediately. After initial password is learned, relearn procedure will have to be performed to change password.
  1. Clear all DTCs. See scan tool manufacturer's instructions. Turn ignition switch to OFF position. Replace component(s) as necessary.
  2. With transmission in Park (A/T) or Neutral (M/T), turn ignition switch momentarily to START position (engine will not start). Leave ignition switch in RUN position (engine off). After 10 minutes, when SECURITY light turns off, turn ignition switch to OFF position for 5 seconds.
  3. Repeat step  2 twice more. Turn ignition switch to OFF position. Auto learn procedure will be completed during next start attempt. Clear all DTCs.
scientia non olet · About LEMON Manuals