LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Computer Relearn Procedures) >> General Motors (Cars) >> Century, Grand PRIX, Impala, Intrigue, Lumina, Monte CARLO & Regal >> PASS-Key® III System Auto Learn Procedure (Grand Prix)

PASS-Key® III System Auto Learn Procedure (Grand Prix)

WARNING: This page does not describe the selected car, but rather 98 other vehicles, including the 2001 Saturn SW2, 2001 Saturn SL2, 2001 Saturn SL1, 2001 Saturn SL, and 2001 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: PASS-Key® III system auto learn procedure must be performed if all keys are lost, or Powertrain Control Module (PCM), PASS-Key® III module, ignition lock cylinder, steering column assembly or ignition key are replaced. A password is communicated between PASS-Key® III module and PCM to provide engine operation. If PCM is replaced, the PCM must learn the password from the PASS-Key® III module.
  1. Insert a valid mechanical coded unlearned master ignition key (Black) in the ignition switch. Place ignition switch in RUN position. The SECURITY indicator light will flash once per second for 10 minutes for the length of the auto learn timer.
  2. When auto learn timer expires and SECURITY indicator light goes off, place ignition switch in LOCK position. Wait 5 seconds.
  3. Repeat steps  1 and  2 2 more times. Insert the newly learned ignition key in ignition switch.
  4. Place ignition switch in RUN position. The SECURITY indicator light should remain off to indicate that ignition key was learned. This will be the only learned key. To program more keys, see PASS-KEY® III SYSTEM QUICK LEARN PROCEDURE (GRAND PRIX) . If security indicator does not remain off, repeat procedure. Use scan tool to clear any DTCs.
scientia non olet · About LEMON Manuals