Password Learn Procedure For Anti-Theft System
WARNING: This page does not describe the selected car, but rather 98 other vehicles, including the 2001 Saturn SW2, 2001 Saturn SL2, 2001 Saturn SL1, 2001 Saturn SL, and 2001 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If Tech 2 scan tool and Techline terminal is available, a 10 minute procedure is available. Follow scan tool manufacturer's instructions.
- Turn ignition switch to ON position, engine off. Attempt to start engine, then release key to ON position (vehicle will not start). Observe SECURITY telltale, after approximately 10 minutes, telltale will turn off. Turn ignition switch to OFF position and wait 5 seconds.
- Repeat step 1 two more times for a total of 3 cycles/30 minutes. Vehicle is now ready to relearn Passlock™ Sensor Data Code and/or passwords on next ignition switch transition from off to crank.
- Start engine (vehicle has now learned Passlock™ Sensor Data Code and/or password). Using scan tool, clear DTCs.
NOTE:
Vehicle learns Passlock™ Sensor Data Code and/or password on next ignition switch transition from off to crank. You must turn ignition off before attempting to start vehicle.