LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 496 (Disc Brake System) >> Removal & Installation >> Front Brake Rotor >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support front of vehicle. Remove front wheel assemblies. Remove in the order indicated in the illustration. See Figure.
  2. Machine rotor if lateral runout exceeds specification. Replace rotor if measured thickness is less than specified minimum thickness. See DISC BRAKE SPECIFICATIONS .
  3. To install, reverse removal procedure. Tighten all fasteners to specification. See TORQUE SPECIFICATIONS . Bleed air from system. See BLEEDING BRAKE SYSTEM .
    NOTE: Remove any rust or grime on the contact face of the disc plate and wheel hub. Push the piston fully inward using the Caliper Piston Expander (49-0221-600C). See Figure. To install the disc pad. After installation, pump the brake pedal a few times and verify that the brakes do not drag.
scientia non olet · About LEMON Manuals