Stoplight Switch: Installation

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Install the electrical connector on the stoplight switch (1). See Fig 1 .
Position the stoplight switch (1) on the pushrod (2) and install on the brake pedal pin. See Fig 1 .
Install the pushrod retainer to the brake pedal pin. The retainer will snap into place.
Install the left sound insulator.

Fig 1: Identifying Stoplight Switch Components

Courtesy of GENERAL MOTORS CORP.