LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 495 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Rear Disc Brake Backing Plate >> Removal

Rear Disc Brake Backing Plate: Removal

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Remove the tire and wheel assembly.
  2. Remove the park brake cable from the rear brake caliper. See PARK BRAKE CABLE  .
  3. Remove the brake caliper and bracket assembly. See BRAKE CALIPER BRACKETS  .
  4. Remove the rear brake rotor. See BRAKE ROTORS  .
  5. Remove the park brake shoe. See PARK BRAKE SHOE  .
  6. Remove the rear drive axle. See appropriate REAR DRIVE AXLE article in DRIVELINE/AXLES.
  7. Remove the retaining nuts from the backing plate.
  8. Remove the backing plate from the rear axle housing flange.
scientia non olet · About LEMON Manuals