LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 495 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Power Brake Booster >> Installation

Power Brake Booster: Installation

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the gasket and the vacuum booster assembly.
  2. Install the vacuum booster mounting nuts on the vacuum booster. Tighten the vacuum booster mounting nuts. See TORQUE SPECIFICATIONS  .
  3. Position the stoplight switch (1) on the pushrod (2) and install on the brake pedal pin. See Figure .
  4. Install the pushrod retainer (3) to the brake pedal pin (4). The retainer will snap into place. See Figure .
  5. Install the left closeout/insulator panel.
  6. Install the vacuum hose to the vacuum booster and to the engine.
  7. Install the master cylinder. See MASTER CYLINDER  .
scientia non olet · About LEMON Manuals