Master Cylinder: Installation
WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Before installing the master cylinder, bench bleed the master cylinder. See MASTER CYLINDER BENCH BLEEDING under BLEEDING, FILLING & FLUSHING BRAKE SYSTEM.
- Install the master cylinder assembly.
- Install the master cylinder mounting nuts. Tighten the master cylinder mounting nuts. See TORQUE SPECIFICATIONS .
- Remove the rubber plugs from the brake lines. Connect the brake pipes. See Figure . Tighten the brake pipe fittings. See TORQUE SPECIFICATIONS .
- Connect the master cylinder fluid level sensor connector.
- Bleed the hydraulic brakes system. See MANUAL BLEEDING under BLEEDING, FILLING & FLUSHING BRAKE SYSTEM.