LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 495 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Master Cylinder Reservoir >> Removal

Master Cylinder Reservoir: Removal

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the brake master cylinder assembly. See MASTER CYLINDER  .
  2. Drain the brake fluid from the reservoir.
    3. CAUTION: DO NOT clamp on the master cylinder body. Doing so may damage the master cylinder.
  3. Clamp the flange of the master cylinder body in a vise.
  4. Remove the retaining pins for the brake master cylinder reservoir.
  5. Remove the reservoir from the brake master cylinder.
  6. Remove the seals from the brake master cylinder.
  7. Clean the master cylinder area with denatured alcohol, or equivalent.
  8. Dry the master cylinder with non-lubricated, filtered air.
scientia non olet · About LEMON Manuals