LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 495 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Brake Pedal Assembly >> Installation

Brake Pedal Assembly: Installation

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. If the brake pedal pivot bushing is damaged or worn, replace the bushing using the following procedure:
    1. Squeeze the end that will be facing the brake pedal pivot nut.
    2. Insert the bushing into the pivot hub just enough to hold the bushing in place.
    3. Push the bushing through the hub until the bushing snaps in place.
  2. Install the brake pedal.
    3. NOTE: The brake pedal pivot bolt is a prevailing torque bolt and must be replaced each time the bolt is removed.
  3. Install the NEW brake pedal pivot bolt and the brake pedal pivot nut. Tighten the brake pedal pivot bolt. See TORQUE SPECIFICATIONS  .
  4. Install the stoplight switch to the brake pedal. See STOPLIGHT SWITCH  under REMOVAL & INSTALLATION.
  5. Install the closeout/insulator panel.
scientia non olet · About LEMON Manuals