Master Cylinder Fluid Level Sensor: Removal

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the electrical connector from the fluid level sensor.
Remove the fluid level sensor. See Fig 1. Use needle nose pliers in order to compress the switch locking tabs at the outboard side of the master cylinder. See Fig 2.

Fig 1: Locating Fluid Level Sensor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Fig 2: Depressing Locking Tabs On Fluid Level Sensor

Courtesy of GENERAL MOTORS CORP.