LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 494 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Brake Hardware >> Installation - Front Disc

Installation - Front Disc

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate and Install the caliper pin boots to the disc brake caliper mounting bracket.
  2. Lubricate and Install the caliper pins to the disc brake caliper mounting bracket.
  3. Lubricate and Install the disc brake pad retainers to the disc brake caliper bracket.
  4. Install the disc brake pads to the disc brake caliper bracket.
  5. Install the disc brake caliper to the mounting bracket.
  6. Install the disc brake caliper bolts. Tighten the disc brake caliper bolts to specification. See TORQUE SPECIFICATIONS .
  7. Apply and release the brake pedal (3/4 stroke) as many times as necessary in order to obtain a firm brake pedal.
  8. Install the tire and wheel.
  9. Lower the vehicle.
  10. Fill the master cylinder to the proper level. See MASTER CYLINDER RESERVOIR  under BLEEDING, FILLING & FLUSHING BRAKE SYSTEM.
scientia non olet · About LEMON Manuals