LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 493 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Disc Brake Hardware - Rear >> Installation

Disc Brake Hardware - Rear: Installation

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the caliper pin boots to the disc brake caliper mounting bracket.
  2. Install the caliper pins to the disc brake caliper mounting bracket.
  3. Install the disc brake pad retainers.
  4. Install the disc brake pads.
  5. Install the brake caliper assembly. See BRAKE CALIPER - REAR .
  6. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
  7. Slowly release the brake pedal.
  8. Wait 15 seconds, then repeat steps  6 and  7 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
  9. Fill the brake master cylinder to the proper level. See MASTER CYLINDER RESERVOIR FILLING  under BLEEDING.
scientia non olet · About LEMON Manuals