LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 493 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Brake Caliper - Front Dual Piston >> Installation

Brake Caliper - Front Dual Piston: Installation

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the brake caliper on the mounting bracket.
  2. Install the brake caliper bolts to the mounting bracket. Tighten the brake caliper bolts to specification. See TORQUE SPECIFICATIONS .
  3. Install the brake hose bolt and washers. Tighten the brake hose bolt to specification. See TORQUE SPECIFICATIONS .
  4. Fill the brake master cylinder to the proper level. See MASTER CYLINDER RESERVOIR FILLING  under BLEEDING.
  5. Bleed the brake calipers. See HYDRAULIC BRAKE SYSTEM - MANUAL  or HYDRAULIC BRAKE SYSTEM - PRESSURE  under BLEEDING.
  6. Install the tire and wheel assembly.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals