LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 493 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Adjusting Screw >> Removal

Adjusting Screw: Removal

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the tire and wheel assembly.
  3. Remove the brake drum. See BRAKE DRUM .
  4. Remove the brake shoe return springs. See Figure.
  5. Remove the brake shoe guide.
  6. Remove the hold down springs.
  7. Remove the hold down pins.
  8. Remove the actuator lever and the actuator lever pivot.
  9. Remove the actuator lever and the lever pivot.
  10. Remove the lever return spring.
  11. Remove the park brake strut and the strut spring.
  12. Remove the adjusting screw assembly and the adjusting screw spring from the brake shoes.
  13. Inspect all remaining parts for discoloration due to heat or stress. Replace parts as needed.
scientia non olet · About LEMON Manuals