LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 491 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Proportioning Valve >> Installation

Proportioning Valve: Installation

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install proportioning valve assembly to vehicle. Install and tighten proportioning valve assembly bracket mounting bolts.
  2. Remove plugs from proportioning valve assembly ports. Remove caps or plugs from master cylinder brake pipe ends. Connect master cylinder brake pipes to proportioning valve assembly. Tighten brake pipe fittings at proportioning valve assembly to specification. See TORQUE SPECIFICATIONS  .
  3. Remove caps or plugs from caliper and wheel cylinder brake pipe ends. Connect caliper and wheel cylinder brake pipes to proportioning valve assembly. Tighten brake pipe fittings at proportioning valve assembly.
  4. Bleed hydraulic brake system. See BLEEDING BRAKE SYSTEM  . Remove and discard shop towel into an approved container.
scientia non olet · About LEMON Manuals