LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Rear Suspension System) >> Troubleshooting >> Ride Too Hard

Ride Too Hard

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Did you review the general description and perform the necessary inspections? If yes, proceed to next step. If no, see SYMPTOMS .
  2. Verify that the ride is too hard. Does the vehicle ride normally? If yes, system is okay. If no, proceed to next step.
  3. Inspect the tires for the proper inflation pressure. Is the tire inflation pressure correct? If yes, go to step  5. If no, proceed to next step.
  4. Inflate the tires to the correct pressure. When complete, proceed to next step.
  5. Inspect the springs, struts and shock absorbers for wear or damage. Are any of the components the worn or damaged? If yes, proceed to next step. If no, go to step  7.
  6. Replace all of the worn or damaged components. When complete, proceed to next step.
  7. Inspect the automatic level control system. Repair as necessary. When complete, proceed to next step.
  8. Operate the system in order to verify the repair. If yes, system is okay. If no, go to step  3.
scientia non olet · About LEMON Manuals