Wheel Stud: Installation
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
- Install the NEW stud from the back side of the hub. See Fig 1.
- Install flat washers on the wheel stud.
- With the flat side of a wheel nut against the washers, tighten the wheel nut until the wheel stud head seats against the wheel hub flange.
- Install the brake rotor.
- Install the tire and wheel assembly.
- Lower the vehicle.
NOTE:
Ensure that the wheel stud is fully seated against the wheel hub flange.