LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Rear Suspension System) >> Removal & Installation >> Stabilizer Shaft >> Installation

Stabilizer Shaft: Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the stabilizer shaft and the insulator. See Figure.
  2. Install the insulator into the clamp with the slit forward.
  3. Bend the link downward to close around the insulator. Center the stabilizer shaft.
  4. Install the clamp bolt.
  5. Install the link assembly insulators, the sleeve, and the retainers.
  6. Install the support bolt and the nut.
    • Tighten the link assembly bolt to 11 Ft. Lbs. (15 N.m).
    • Tighten the clamp bolt to 24 Ft. Lbs. (33 N.m).
  7. Install the height sensor link to the control arm.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals