LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Rear Suspension System) >> Removal & Installation >> Stabilizer Shaft Link >> Installation

Stabilizer Shaft Link: Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosely install the stabilizer link insulators, washers, nut and bolt. See Figure. Tighten the stabilizer link nut to 13 Ft. Lbs. (17 N.m).
  2. Lower the vehicle.
scientia non olet · About LEMON Manuals