LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Rear Suspension System) >> Removal & Installation >> Coil Spring Insulators >> Removal

Coil Spring Insulators: Removal

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Tools Required: Steering Linkage & Tie Rod Puller (J-24319-B).
  1. Raise and support the vehicle.
  2. Support the control arm with a jack stand.
  3. Remove the automatic level control air tube from the shock.
  4. Remove the lower shock absorber lower retaining bolts. See Figure.
  5. Remove the adjustment link retaining nut. See Figure.
    CAUTION: When separating a linkage joint, do not try to disengage the joint by driving a wedge between the joint and the attached part. Seal damage may result.
  6. Using J-24319-B separate the adjustment link from the lower control arm. See Figure.
  7. Slowly lower the control arm onto the support assembly.
  8. Pry under the lower spring insulator. Remove the spring with the insulator. See Figure.
  9. Remove the jounce bumper, if necessary, by pulling downward.
scientia non olet · About LEMON Manuals