LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 456 (Supplemental Inflatable Restraint System) >> Removal & Installation >> Air Bag Modules >> Removal & Installation (Driver-side)

Removal & Installation (Driver-side)

WARNING: This page is about a different car, the 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See ZONE 3  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Turn ignition on. Turn steering wheel so that 2 holes on back of steering wheel are accessible. Install Air Bag Module Remover (J-44248) into holes. See Figure. Release driver-side air bag module spring clips. Turn steering wheel 180 degrees and repeat procedure for remaining 2 spring clips. Pull driver-side air bag module away from steering wheel.
  3. Remove Connector Position Assurance (CPA) clip from driver-side air bag connector and disconnect connector. See Figure. Remove horn lead from steering wheel. Turn horn contact lead 1/4 turn counterclockwise to release from steering wheel. Remove horn contact lead from steering column. Remove driver-side air bag module.
  4. To install, reverse removal procedure. Activate air bag system. See ZONE 3  under DISABLING & ACTIVATING AIR BAG SYSTEM.
scientia non olet · About LEMON Manuals