LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 455 (Supplemental Inflatable Restraint System) >> Removal & Installation >> Air Bag Modules >> Removal & Installation (Driver-side)

Removal & Installation (Driver-side)

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See ZONE 3  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Turn steering wheel 90 degrees to gain access to rear steering wheel holes. Insert flat-blade screw driver into each hole and push leaf springs to release air bag module retaining pins. See Fig 1. Turn steering wheel 180 degrees to access remaining 2 holes. Pull air bag module away from steering wheel. Disconnect air bag wire module wire harness from clips on air bag module and steering wheel. Remove Connector Position Assurance (CPA) clips from driver-side air bag module connectors. Disconnect connectors. Remove driver-side air bag module.
  3. To install, reverse removal procedure. Ensure leaf springs are securely connected on all notched pins. Activate air bag system. See ZONE 3  under DISABLING & ACTIVATING AIR BAG SYSTEM.
Fig 1: Identifying Driver-side Air Bag Module Leaf Spring & Pin
G99C27583Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals