LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 454 (Supplemental Inflatable Restraint System) >> Diagnostic Tests >> DTC B1001: Option Configuration Error >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. If SIR diagnostic system check has been performed, go to next step. If SIR diagnostic system check has not been performed, go to SIR DIAGNOSTIC SYSTEM CHECK .
  2. Using scan tool, verify that PCM is programmed with correct VIN. If VIN is not correct, go to next step. If VIN is correct, go to step  4.
  3. Using scan tool, program correct VIN into PCM. Go to step  9.
  4. If BCM was not replaced, go to next step. If BCM was replaced, go to step  8.
  5. Using scan tool, program BCM to learn restraints identification from SDM. When programming is complete, go to step  9. If VIN is not correct, go to next step.
  6. If SDM was not replaced, go to next step. If SDM was replaced, go to step  8.
  7. Replace SDM. See SENSING & DIAGNOSTIC MODULE (SDM)  under REMOVAL & INSTALLATION. Go to next step.
  8. Using scan tool, reprogram VTD system. Go to next step.
  9. Reconnect all SIR components. Using scan tool, clear DTC's. Road test vehicle, then check for DTC's. If DTC is retrieved, go to step  2. If DTC is not retrieved, system is normal.
scientia non olet · About LEMON Manuals