LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 454 (Supplemental Inflatable Restraint System) >> Diagnostic Tests >> DTC B0098: Incorrect PPS Verification Identification >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. If SIR Diagnostic System Check has been performed, go to next step. If SIR Diagnostic System Check has not been performed, go to SIR DIAGNOSTIC SYSTEM CHECK .
  2. If PPS was replaced, go to next step. If PPS was not replaced, go to step  4.
  3. Inspect PPS and verify correct PPS was installed using PPS part number. If PPS is correct, go to next step. If PPS is not correct, go to step  6.
  4. If SDM was replaced, go to next step. If SDM was not replaced, go to step  6.
    NOTE: Use Digital Multimeter (J-39200) and Connector Test Adapter Kit (J-35616-A) or Flat WIre Probe Adapter Kit (J-42675) when performing electrical tests.
  5. Inspect SDM and verify correct SDM was installed using SDM part number. If SDM is correct, go to next step. If SDM is not correct, go to step  8.
  6. Replace PPS. See PASSENGER PRESENCE SYSTEM (PPS)  under REMOVAL & INSTALLATION. Go to next step.
  7. Reconnect all SIR and PPS components. Verify all components and connectors are installed correctly. Using scan tool, clear all SIR and PPS DTC's. Rezero PPS. See PASSENGER PRESENCE SYSTEM REZEROING PROCEDURE  under DIAGNOSTICS. Road test vehicle. If DTC resets, go to next step. If DTC does not reset, system is normal.
  8. Replace SDM. See SENSING & DIAGNOSTIC MODULE (SDM)  under REMOVAL & INSTALLATION. Go to next step.
  9. Reconnect all SIR and PPS components. Verify all components and connectors are installed correctly. Using scan tool, clear all SIR and PPS DTC's. Rezero PPS. See PASSENGER PRESENCE SYSTEM REZEROING PROCEDURE  under DIAGNOSTICS. Road test vehicle. If DTC resets, go to step  2. If DTC does not reset, system is normal.
scientia non olet · About LEMON Manuals