LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 453 (Supplemental Inflatable Restraint System) >> Removal & Installation >> Air Bag Modules >> Removal & Installation (Side Impact AIR Bag)

Removal & Installation (Side Impact AIR Bag)

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. For driver side impact air bag module, see ZONE 7  under DISABLING & ACTIVATING AIR BAG SYSTEM.. For passenger side impact air bag module, see ZONE 9  under DISABLING & ACTIVATING AIR BAG SYSTEM..
  2. Remove applicable front seat back cover. See Fig 1. Disconnect side impact air bag module electrical connector. Remove side impact air bag module nuts. Remove side impact air bag module.
  3. To install, reverse removal procedure. Tighten side impact air bag module nuts to specification. See TORQUE SPECIFICATIONS . Activate air bag system. For passenger side impact air bag module, see ZONE 9  under DISABLING & ACTIVATING AIR BAG SYSTEM.. For driver side impact air bag module, see ZONE 7  under DISABLING & ACTIVATING AIR BAG SYSTEM..
Fig 1: Identifying Side Impact Air Bag Module
G99H27661Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals