Removal & Installation (Passenger-side)

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See ZONE 5 under DISABLING & ACTIVATING AIR BAG SYSTEM.
Remove glove box. Remove Connector Position Assurance (CPA) clip from air bag module connector and disconnect passenger-side air bag module connector. See Figure. Remove passenger-side air bag module mounting nuts and bolt. See Fig 1. Remove passenger-side air bag module from instrument panel.
To install, reverse removal procedure. Tighten passenger-side air bag module mounting nuts and bolt to specification. See TORQUE SPECIFICATIONS . Activate air bag system. See ZONE 5 under DISABLING & ACTIVATING AIR BAG SYSTEM.

Fig 1: Identifying Passenger-side Air Bag Module

Courtesy of GENERAL MOTORS CORP.