Zone 6
WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Turn steering wheel to place vehicle wheels in straight-ahead position. Turn ignition off and remove key. Remove AM2 fuse from junction block, located in lower left side of instrument panel. See Figure. Disconnect negative battery cable.
- Disable Zone 9. See ZONE 9 . Remove passenger-side front and rear door sill plates. Remove lower B-pillar trim panel. Remove seat belt pretensioner. See SEAT BELT PRETENSIONER under REMOVAL & INSTALLATION. Remove Connector Position Assurance (CPA) clip from Side Impact Sensor (SIS). See Figure. Disconnect SIS electrical connector.