LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 453 (Supplemental Inflatable Restraint System) >> Disabling & Activating Air Bag System >> Activating System >> Zone 6

Zone 6

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure ignition is off and key is removed. Connect electrical connector to passenger-side Side Impact Sensor (SIS). See Figure. Install Connector Position Assurance (CPA) clip. Install seat belt pretensioner. See SEAT BELT PRETENSIONER  under REMOVAL & INSTALLATION. Install lower B-pillar trim panel. Install front and rear door sill plates. Activate Zone 9. See ZONE 9 .
  2. Connect negative battery cable. Install AM2 fuse in junction block, located in lower left side of instrument panel. Staying well away from air bag modules, turn ignition on. Check air bag system for proper operation. See SYSTEM OPERATION CHECK .