Diagnostic Procedure
WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- If SIR diagnostic system check has been performed, go to next step. If SIR diagnostic system check has not been performed, go to SIR DIAGNOSTIC SYSTEM CHECK .NOTE: Use Digital Multimeter (J-39200) and Flat WIre Probe Adapter Kit (J-42675) when performing electrical tests.
- Turn ignition off. Disconnect SDM connector. Measure resistance of diagnostic request circuit between SDM connector terminal No. 19 (Pink/Black wire) and ground. If resistance is less than infinite, repair short to ground in diagnostic request circuit. If resistance is infinite, go to next step.
- Replace SDM. See SENSING & DIAGNOSTIC MODULE (SDM) under REMOVAL & INSTALLATION. Go to next step.
- Road test vehicle. If condition is corrected, system is okay. If condition is not corrected, go to step 2.