LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 452 (Engine Controls - Self-Diagnostics - 6.0L Bi-Fuel & CNG) >> Self-Diagnostic System >> Diagnostic Starting Point - Engine Controls

Diagnostic Starting Point - Engine Controls

WARNING: This page is about a different car, the 2003 GMC Sierra and 2003 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Diagnosis of computerized engine control system should be performed in the following order:

  1. Ensure all engine systems not related to computer system are operating properly. DO NOT proceed with testing unless all other problems have been repaired. Diagnostic system check must be performed before using specific DTC testing procedure. See DIAGNOSTIC SYSTEM CHECK - ALTERNATIVE FUELS - ENGINE CONTROLS .
  2. If no DTCs are present and a driveability problem exists, see SYMPTOMS in TROUBLE SHOOTING - NO CODES - 6.0L CHEVY EXPRESS, SAVANA, SIERRA & SILVERADO - BI-FUEL & CNG article. Doing so will help identify proper system or component to check in SYSTEM & COMPONENT TESTING - 6.0L CHEVY EXPRESS, SAVANA, SIERRA & SILVERADO - BI-FUEL & CNG article.
  3. After necessary repairs are made, clear DTCs, verify vehicle will enter "Closed Loop" operation and ensure DTC does not reset.

scientia non olet · About LEMON Manuals