Removal (8.1L)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
An 8-digit part identification number can be found on the fuel rail assembly. Refer to this number if service or part replacement is necessary.
- Disconnect negative battery cable. Loosen retaining bolt on intake manifold sight shield at top of engine. Remove intake manifold sight shield from top of engine. Remove intake manifold sight shield bracket nuts and bracket.
- Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE . Before removal, clean fuel rail assembly with a spray type engine cleaner, such as GM X-30A. DO NOT use any solvent that contains Methyl Ethyl Ketone (MEK). Solvents containing MEK may damage fuel system components.
- Disconnect harness connectors from EVAP purge solenoid, generator and Electronic Throttle Control (ETC). Remove engine wiring harness bolt studs. Position upper engine wiring harness aside.
- Label injector harness connectors for installation reference. Pull fuel injector harness connector top upward, but not past the White portion of the connector. See Fig 1. Push fuel injector harness connector release tab inward, to release connector from fuel injector. Disconnect remaining injector harness connectors in same manner.
- Disconnect the fuel feed and return lines from the fuel rail. Disconnect fuel pressure regulator vacuum line. Remove the fuel rail attaching bolts and remove the fuel rail. Remove fuel injector retainer(s) and remove fuel injector(s) from fuel rail. See Figure. Remove and discard fuel injector "O" rings.
CAUTION:
When disconnecting injector harness connectors, DO NOT use pliers or other hand tools, as connector ends may become damaged.