LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 450 (Engine Controls - Removal & Installation - V6 & V8) >> Sensors & Switches >> Manifold Absolute Pressure Sensor >> Removal (3.1L & 3.4L)

Removal (3.1L & 3.4L)

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix, 2003 Chevrolet Monte Carlo, 2003 Chevrolet Impala, 2003 Buick Regal, and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Turn OFF the ignition. Remove the screws that attach the Manifold Absolute Pressure (MAP) sensor to the bracket. See Figure. Disconnect the MAP sensor electrical connector. Disconnect the MAP sensor inlet vacuum hose. Remove the MAP sensor from the bracket.