LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 450 (Engine Controls - Removal & Installation - V6 & V8) >> Fuel Systems >> Fuel Filler Tube >> Installation

Fuel Filler Tube: Installation

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix, 2003 Chevrolet Monte Carlo, 2003 Chevrolet Impala, 2003 Buick Regal, and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the fuel tank if previously removed. See FUEL TANK . Install the fuel filler tube into the fuel filler hose. Position the fuel filler tube for the best fit and alignment then secure the fuel filler tube hose clamp. See Fig 1 and TORQUE SPECIFICATIONS  .
  2. Install the bolt to the fuel filler tube ground wire. Tighten to specifications, see TORQUE SPECIFICATIONS .
  3. Install the wheel house opening fuel filler tube cover. Lower the vehicle. Install the sealing ring around the fuel filler tube. Add fuel to the fuel tank. Inspect for fuel leaks. Install the fuel filler cap and close the fuel filler door.
Fig 1: Installing Fuel Filler Hose Clamp
G00112789Courtesy of GENERAL MOTORS CORP.