Fuel Injection Control Module: Installation
WARNING: This page is about a different car, the 2003 GMC Sierra and 2003 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Loosely install all of the FICM hold-down screws. See Fig 1 . Tighten the screws to specification. See TORQUE SPECIFICATIONS . Connect the electrical connector to the FICM and install the connector position assurance lock. Install the right side wheelhouse panel. Lower the vehicle.