Crankshaft Position Sensor: Installation
WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Install CKP sensor into engine using NEW "O" ring lubricated with clean engine oil. Tighten CKP sensor retaining bolt to specification. See TORQUE SPECIFICATIONS . Reconnect CKP sensor harness connector. Lower vehicle. Perform CKP SYSTEM VARIATION LEARN PROCEDURE under PROGRAMMING.
- Install the CKP sensor and CKP sensor bolt. Tighten the CKP sensor bolt to specification. See TORQUE SPECIFICATIONS .
- Connect the CKP sensor electrical connector. Install the positive cable to the starter stud. Install the starter lead nut. and Tighten the nut to specification. Install the starter solenoid lead to the solenoid stud. Install the starter solenoid nut. Tighten the starter solenoid nut to specification.
- Slide the starter rearward. Install and tighten the starter bolts to specification. Connect the oil level sensor electrical connector. Install the right flywheel cover bolt and tighten to specification. Lower the vehicle.
- Connect the negative battery cable. Tighten the negative battery cable bolt to specification. Perform CKP sensor variation learn procedure. See CKP SYSTEM VARIATION LEARN PROCEDURE under PROGRAMMING.