Ignition System
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Soak the secondary ignition system with water from a spray bottle. Soaking the secondary ignition system may help locate damaged or deteriorated components. Look and listen for arcing or misfiring as you apply the water.
- Test for improper ignition voltage output with the Spark Tester (J 26792).
- Remove the spark plugs and inspect for the following:
- Correct Heat Range
- Wet Plugs
- Cracks
- Wear
- Improper Gap
- Burned Electrodes
- Heavy Deposits
- An improper spark plug gap will cause a driveability problem. Gap the spark plugs using a wire gauge gap tool.
- Determine the cause of the fouling before replacing the spark plugs.
- Monitor the Misfire Current Counters while driving the vehicle within the conditions that the misfire occurred. If a misfiring cylinder can be located, use DTC P0300 for diagnosis. See DTC P0300: ENGINE MISFIRE DETECTED in SELF-DIAGNOSTICS - 5.7L CORVETTE article.
- Inspect for loose ignition coil grounds.