Removal & Installation
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Remove the engine cover. Disconnect the electrical connector. Remove the screws holding the ignition control module and the heat sink to the bracket. Remove the ignition control module and the heat sink. Install the ignition control module and the heat sink on the bracket with the screws. Reconnect the electrical connectors. Install the engine cover.