Installation (Engine Has Been Rotated With Distributor Removed)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- If engine was rotated after distributor was removed, remove No. 1 spark plug. Place finger over cylinder No. 1 spark plug hole. Crank engine slowly until compression is felt. The 2 marks on the crankshaft pulley should align with the 2 engine front cover tabs. See Fig 2. If necessary, rotate engine by hand until timing marks are fully aligned.
- Align White paint mark on bottom stem of distributor and the pre-drilled indent hole in the bottom of the gear. See Fig 3. Using a long screwdriver, align the oil pump driveshaft to the drive tab on the distributor.
- Carefully lower distributor into engine with flat side of distributor housing facing toward front of vehicle. See Fig 4. Once distributor is fully seated, distributor rotor should be aligned with pointer cast into distributor housing.
- If distributor rotor is not properly aligned, remove distributor and repeat procedure until mark aligns properly. Install distributor hold-down bolt and tighten to specification. To complete installation, reverse removal procedure. See TORQUE SPECIFICATIONS .