LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 440 (Engine Controls - Troubleshooting - No Codes) >> INTERMITTENTS >> Electromagnetic Interference (EMI) & Electrical Noise

Electromagnetic Interference (EMI) & Electrical Noise

WARNING: This page is about a different car, the 2003 Cadillac Seville and 2003 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.

Some electrical components or circuits are sensitive to Electromagnetic Interference (EMI) or other types of electrical noise. Perform the following procedures:

  1. A misrouted harness that is too close to high voltage/high current devices such as secondary ignition components, motors, generator, etc. These components may induce electrical noise on a circuit that could interfere with normal circuit operation.
  2. Electrical system interference caused by a malfunctioning relay, PCM driven solenoid, or switch. These conditions cause a sharp electrical surge. Normally, the problem will occur when the malfunctioning component is operating.
  3. Improper installation of non-factory (aftermarket) add-on accessories such as lights, 2 way radios, amplifiers, electric motors, etc.
  4. Test for an open diode across the A/C compressor clutch, and for other open diodes.
  5. Test the generator for a bad rectifier bridge that may be allowing AC noise into the electrical system.