Removal Procedure
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the engine sight shield, if required. Refer to Engine Sight Shield Replacement (4.8L, 5.3L, and 6.0L (LQ4)) or Engine Sight Shield Replacement (6.0L (LQ9)) .
- Remove the connector position assurance (CPA) lock.
- Disconnect the main electrical connector (2) feeding the ignition coils.
- Remove the harness clips (1).
- Reposition the engine harness, if necessary.
- Remove the spark plug wires from the ignition coils.
- Twist each plug wire 1/2 turn.
- Pull only on the boot in order to remove the wire from the ignition coil.
- Remove the ignition coil bracket studs from the rocker arm cover.
- Remove the ignition coils and bracket from the rocker arm cover.
- Remove the positive crankcase ventilation (PCV) hose from the rocker arm cover.
- Remove the valve rocker arm cover bolts.
- Remove the valve rocker arm cover.
- Remove the gasket (1) from the rocker cover.
- Discard the OLD gasket.
- Clean and inspect the rocker arm cover. Refer to Valve Rocker Arm Cover Cleaning and Inspection in Engine Mechanical - 4.8L, 5.3L, and 6.0L Unit Repair.