Installation Procedure
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the right fuel rail cover.
Tighten: Tighten the bolts to 9 N.m (80 lb in)
- Install the surge tank/heater hoses to the clip on the right fuel rail cover.
- Install the left fuel rail cover.
Tighten: Tighten the bolts to 9 N.m (80 lb in)
- Install the sight shield retainer and the bolts, if required.
Tighten: Tighten the retainer bolts to 5 N.m (44 lb in).
- Install the intake manifold sight shield to the retainer.
Tighten: Tighten the intake manifold sight shield bolt to 9 N.m (80 lb in)
NOTE:
Refer to FASTENER NOTICE
in Cautions and Notices.
NOTE:
Use care when installing the engine sight shield to avoid contacting the manifold absolute pressure (MAP) sensor wire harness connector. Loss of engine performance or engine damage may result.