LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 437 (Engine Mechanical - 4.8L, 5.3L, & 6.0L (On-Vehicle)) >> Repair Instructions >> Engine Sight Shield Replacement (4.8L, 5.3L, and 6.0L (LQ4)) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Accelerator Control Cable At Sight Shield Retainer
    GM684150Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the sight shield retainer and the bolts, if required.

    Tighten:  Tighten the retainer bolts to 5 N.m (44 lb in).

  2. Install the cruise control cable clip to the retainer.
    3. Fig 2: Intake Manifold Sight Shield & Bolts (4.8L, 5.3L, and 6.0L (LQ4))
    GM684149Courtesy of GENERAL MOTORS CORP.
  3. Install the accelerator control cable clip to the retainer.
    4. Fig 3: View Of Top Engine Cover
    GM665886Courtesy of GENERAL MOTORS CORP.
    NOTE: Use care when installing the engine sight shield to avoid contacting the manifold absolute pressure (MAP) sensor wire harness connector. Loss of engine performance or engine damage may result.
  4. Install the intake manifold sight shield to the retainer.

    Tighten:  Tighten the bolt to 10 N.m (89 lb. in.).

scientia non olet · About LEMON Manuals