Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of J 41712 Removing The Oil Pressure Sensor

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Apply sealant GM P/N 12346004, (Canadian P/N 10953480), or equivalent, to the threads of the oil pressure sensor.
Using J 41712 or equivalent, install the oil pressure sensor.
Tighten: Tighten the oil pressure sensor to 20 N.m (15 lb ft).

Fig 2: View Of Oil Pressure Sensor & CMP Sensor Connectors

Courtesy of GENERAL MOTORS CORP.

Connect the oil pressure sensor electrical connector (1).
If necessary, install the engine sight shield. Refer to Engine Sight Shield Replacement (4.8L, 5.3L, and 6.0L (LQ4)) or Engine Sight Shield Replacement (6.0L (LQ9)) .