LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 437 (Engine Mechanical - 4.8L, 5.3L, & 6.0L (On-Vehicle)) >> Repair Instructions >> Engine Mount Replacement - Right >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the exhaust manifold. Refer to EXHAUST MANIFOLD REPLACEMENT - RIGHT (4.8L, 5.3L, AND 6.0L ENGINES) or EXHAUST MANIFOLD REPLACEMENT - RIGHT (8.1L ENGINE) in Engine Exhaust.
    2. Fig 1: View Of Engine Mount-To-Engine Mount Bracket
    GM307275Courtesy of GENERAL MOTORS CORP.
  2. Remove the engine mount-to-engine mount bracket bolts.
  3. Raise and suitably support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  4. Remove the tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  5. Remove the inner wheelhouse panel. Refer to Refer to WHEELHOUSE PANEL REPLACEMENT in Body Front End.
  6. Remove the engine protection shield, if equipped. Refer to ENGINE PROTECTION SHIELD REPLACEMENT in Frame and Underbody.
    7. IMPORTANT: DO NOT raise and/or support the engine by the crankshaft balancer, or oil pan.
  7. Raise and suitably support the engine using adjustable (screw type) jack stands.
    8. Fig 2: Right Engine Mount & Bolts
    GM307279Courtesy of GENERAL MOTORS CORP.
  8. Remove the engine mount to engine bolts.
  9. Remove the right engine mount.
scientia non olet · About LEMON Manuals