LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 437 (Engine Mechanical - 4.8L, 5.3L, & 6.0L (On-Vehicle)) >> Repair Instructions >> Engine Mount Bracket Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Right Engine Mount Bracket & Bolts
    GM678846Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount bracket.
  2. Perform the following procedure prior to installing the engine mount bracket bolts.
    • Remove all traces of the original adhesive patch.
    • Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
    • Apply threadlocker GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the bolts.
    3. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the engine mount bracket bolts.

    Tighten:  Tighten the engine mount bracket bolts to 75 N.m (55 lb ft).

  4. Install the engine mount. Refer to Engine Mount Replacement - Right .
scientia non olet · About LEMON Manuals