LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 437 (Engine Mechanical - 4.8L, 5.3L, & 6.0L (On-Vehicle)) >> Repair Instructions >> Drive Belt Tensioner Replacement - Accessory >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Drive Belt Tensioner & Bolts
    GM647789Courtesy of GENERAL MOTORS CORP.
  1. Install the drive belt tensioner.
  2. Install the drive belt tensioner bolts.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Tighten the drive belt tensioner bolts.

    Tighten:  Tighten the accessory drive belt tensioner bolts to 50 N.m (37 lb ft).

  4. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
scientia non olet · About LEMON Manuals