LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 436 (Engine Performance System Removal & Installation) >> Emission Systems & Sub-Systems >> Secondary Air Injection Pump Vacuum Control Solenoid Valve >> Removal & Installation (2.2L)

Removal & Installation (2.2L)

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Solenoid valve may also be referred to as AIR pump solenoid.

Turn ignition off. Raise and support vehicle. Locate AIR pump solenoid. AIR pump solenoid is located on AIR pump. See Figure. Disconnect vacuum line from AIR pump solenoid. Disconnect AIR pump solenoid harness connector. Remove AIR pump solenoid from AIR pump bracket. To install, reverse removal procedure.

scientia non olet · About LEMON Manuals